Manufacture of Al-Ti-B master alloys by the reaction of complex halide salts with molten aluminium

Murty, B. S. ; Kori, S. A. ; Venkateswarlu, K. ; Bhat, R. R. ; Chakraborty, M. (1999) Manufacture of Al-Ti-B master alloys by the reaction of complex halide salts with molten aluminium Journal of Materials Processing Technology, 89-90 . pp. 152-158. ISSN 0924-0136

Full text not available from this repository.

Official URL: http://www.sciencedirect.com/science/article/pii/S...

Related URL: http://dx.doi.org/10.1016/S0924-0136(99)00135-1

Abstract

The influence of various process parameters, involved during the preparation of Al-Ti-B master alloy by the reaction of halide salts with molten aluminium, on the microstructure and the grain refining behaviour of Al-5Ti-1B master alloys has been studied in detail. The results shows that, morphology of Al3Ti strongly influences the grain refinement behaviour of the master alloy. The grain refining efficiency of the present master alloy compares favourably with the widely used commercial master alloys such as those of LSM and AB. Thermomechanical treatment of as-cast master alloy has resulted in a better grain refinement due to increased nucleating sites caused by the fracture of Al3Ti and the formation of duplex particles. In addition, the grain refining behaviour of Al-0.2 and 2%Cr, Al-0.2 and 2%Zr and Al-0.2, 2 and 7%Si alloys has been studied in detail with conventional (0.2%) as well as higher addition levels of 5/1 TiBAl. The degree of the poisoning effect appears to decrease in the order of Cr, Zr and Si. Mg can counteract the poisoning effect of Si.

Item Type:Article
Source:Copyright of this article belongs to Elsevier Science.
Keywords:Al-Ti-B Master Alloys; Grain Refinement of Al; Thermomechanical Treatment; Poisoning Effect
ID Code:73886
Deposited On:08 Dec 2011 03:46
Last Modified:08 Dec 2011 03:46

Repository Staff Only: item control page