Dwivedi, Sanjeet ; Singh, Bhim (2010) Vector control vs direct torque control comparative evaluation for PMSM drive In: Joint International Conference on Power Electronics, Drives and Energy Systems & 2010 Power India 2010, 20-23 Dec. 2010, New Delhi, India.
Full text not available from this repository.
Official URL: http://ieeexplore.ieee.org/document/5712410/
Related URL: http://dx.doi.org/10.1109/PEDES.2010.5712410
Abstract
This research article deals with the two closed loop speed control techniques namely Vector Control and Direct Torque Control for Permanent Magnet Synchronous Motor Drive. These two control techniques are critically evaluated for the performance comparison in terms of starting response, steady state response and transient condition. The simulation models of the two controllers are developed in Matlab/Simulink and experimental verification is obtained on Digital Signal Processor based hardware setup. The implementation algorithms are developed in assembly codes and power circuit is realized with standard Voltage Source Inverter. The simulation and experimental results shows close agreements and provide good inside for the evaluation of these two control techniques.
| Item Type: | Conference or Workshop Item (Paper) |
|---|---|
| Source: | Copyright of this article belongs to Institute of Electrical and Electronics Engineers. |
| Keywords: | Voltage Source Inverter; Digital Signal Processor; Direct Torque Control; Evaluation; Implementation; Permanent Magnet Synchronous Motor; Vector Control |
| ID Code: | 109140 |
| Deposited On: | 03 Aug 2017 09:30 |
| Last Modified: | 03 Aug 2017 09:30 |
Repository Staff Only: item control page
